Hardware error message when trying to create port-channels

[Jonnyballgame34]

Having a rough day with 3850's, (my second post, two different sites). When trying to create trunks, port-channels I'm getting the message

*May 10 15:47:04.759: %FED_PM_ERRMSG-3-HW_ERROR: 1 fed: Port Manager error -port native vlan: hardware update failed.
*May 10 15:47:04.757: %FED_PM_ERRMSG-3-HW_ERROR: STANDBY:2 fed: Port Manager error -port native vlan: hardware update failed.

Can't seem to find any information on it.  If anyone has seen it, i'd appreciate any advice you have to pass along. Thanks

[Julio E. Moisa]

Hi

Can you verify the native vlan status? are you using the vlan 1 as native or other vlan? 

show vlan

also check this link:

https://supportforums.cisco.com/discussion/13124876/3850-trunking

bug CSCul30426

Conditions:
This defect is seen when trying to build a port-channel between a 3850 and any other switch with the following conditions:
1. The native vlan is in the suspended state
or
2. The native vlan is not present in the vlan database.

Workaround:
Once you created the layer two vlan or change it to an "active" state, the port-channel will form as expected.