Hello,
I have to routers in a lab connected with a serial cable.
When I want to use hdlc as encapsulation, I just have to configure a ip address and the no shutwon command because hdlc is default.
On the DCE side, what I can check with "show controllers", I have to configure clocking rate.
When I want to use ppp, I have to configure ppp as encapsulation, an ip address and no shutdown.
My questions:
1) Are my explanations right?
2) Do I need to set the clocking rate on the DCE when I`m using ppp?
3) Must I configure the bandwith when I`m using ppp oder hdlc?
Thanks in advance :)