Help connecting into 2911 switch module

[Clay Plaga]

I have a cisco 2911 router with a switch module installed and configured. I am trying to connect to the switch module. I am using this command:

service-module gigabitethernet 0/0

Output is: Incomplete command

What is the full command to connect to the switch module?

Thank you.

[Mark Elsen]

   - @Clay Plaga      Add a  ?           to the command to see available options
                              It could be service-module gigabitethernet 0/0 session

  M.

[Clay Plaga]

I added the question mark, but it didn't like the session part. 

Invalid input detected

Thanks

[M02@rt37 · Accepted solution]

Hello @Clay Plaga 

Please refer here

-- https://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/software/feature/guide/eesm_sw.html

***

To open a session from the router to the Cisco enhanced EtherSwitch service module

use the following command:

Router# service-module gigabitethernet0/0 session

***

[Clay Plaga]

Yes, it was :

Router# service-module gigabitethernet1/0 session

On the 2911 router, that interface is labeled:

Gi0/0

Thank you.

[Clay Plaga]

I am using that command.

[M02@rt37]

@Clay Plaga 

Do you assign IP add to Gi0/0 ?

Because it used reverse telnet to connect to the module...