Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco 2911 router with a switch module installed and configured. I am trying to connect to the switch module. I am using this command:service-module gigabitethernet 0/0Output is: Incomplete commandWhat is the full command to connect to the s...
I have CUCM 12.5.1.15900-66 running on a test network. My phones can connect to each other. I am trying to configure music on hold. How do I activate the Cisco IP Voice Media Streaming App service? The Cisco documentation says:In CUCM administration,...
I am taking a new job that requires me to troubleshoot client login and connection to Cisco AnyConnect VPN. I do not have much experience with this task. I have two questions:1. Does Cisco Any connect have a admin center for configuring the applicati...
I have a Cisco 2504 WLC and 3 Cisco 1142n access points on my test network. The 2504 WLC and AP's have been off for a few months and I 'm trying to put the wi-fi back online. I am just learning how to configure this system. The 2504 WLC boots up oka...