How to add 4 3750 into existing stack ?

[r.sagredo]

I have 3 3750  staking swtich with the folowing configuracion:

                                           H/W   Current

Switch#  Role   Mac Address     Priority Version  State

----------------------------------------------------------

1       Member 442b.0350.9400     1      1       Ready              

2       Member 442b.0357.8780     2      1       Ready              

*3       Master 442b.036f.a800        3      1       Ready              

The new switch is installed to be wired to the master switch. the swtich 3 (* 3 Master Ready 442b.036f.a800)

my question is: if you disconnect the wiring from the master stack to connect to the new switch, it is possible that the new switch change the current configuration of stacking.

-Can I just add the new switch with clean configuration without changing the current configuration ?

-how is assigned the stack number? i need the new switch be with the GI4 / x?. I can I manually by assigning ports?

-If I want to the new 3750 member witch lower prioridad, can I change priority before adding to stack?

Thanks in advance,

[Reza Sharifi]

Hi,

Follow this link to add a new switch to your existing stack.

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml#stack3

HTH

[singhaam007 · Accepted solution]

Hi Raul,

hope this will help as its same scenario as yours.

https://community.spiceworks.com/topic/251174-adding-a-new-switch-to-an-existing-stack

thanks