How to configure management port on Cisco 4500

[CiscoBrownBelt]

I have a 4510 that won't take a "set interface" command as shown in some cisco docs to configure the SL0 or any mgmt ports. Maybe I am doing something wrong. Any help?

[Joseph W. Doherty]

Actual available configuration commands are dependent on specific IOS installed (i.e. version and feature set) and hardware (on 45xx, especially the supervisor).

[pieterh]

as mentioned in previous post it depends on the software the switch runs,

BUT there is not only IOS there also exist CatOS, maybe that's the document you refer to ????

Configure the sc0 Interface on Catalyst 4500/4000, 5500/5000, and 6500/6000 Switches That Run CatOS

so first verify what software you are running

try a "show version" or just "version".

[Richard Burts]

I was not aware that 4500 had versions that ran CatOS and I believe that this suggestion is spot on. set interface sounds much more like CatOS than it does IOS.

HTH

Rick

[CiscoBrownBelt]

Yes here:

sh ver
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.08.06.E RELEASE SOFTWARE (fc4)

[Reza Sharifi]

There is no set command unless you are in Rommon mode. 

Can you provide the exact switch model and the sup you are using?  Most newer sups 7, 8, or 9, have a dedicated out-of-band management port that resides in a vrf.

Also, can you explain what you are trying to do?

HTH 

[CiscoBrownBelt]

Yes it is a cisco WS-C4510R+E 

Sup 7-E 10GE (SFP+), 1000BaseX (SFP)   WS-X45-SUP7-E 

I would like to connect the OOBM network to the 4500 mgmt or a vrf type port that can be part of the OOBM network.

[Reza Sharifi]

So, looking at the data sheet (link below) I don't see an OOB port. If that is the case, then you just need to take a regular port and connect it to the out-of-band management switch. No need for any VRFs.

https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-4500-series-switches/data_sheet_c78-612364.html

HTH