HSRP Protocol both router are showing active-active state

[Umesh Prajapati11238]

Hello All,

I hope you are doing well.

Yesterday I was configuring HSRP protocol like R1 & R2 both routers are showing active-active state.

Can anyone please explain what could be an issue if both routers are showing active-active.

And what are best practices of HSRP protocol from which I can learn or explore during HSRP troubleshooting.

Also please share if is there any article so that I can go through.

Please refer the below snapshot from which I want to understand.

Thanks in advanced.

UP

[Kasun Bandara]

@Umesh Prajapati11238 hi check below guide. may be your configuration have to tweak with some settings.

https://community.cisco.com/t5/networking-knowledge-base/hsrp-overview-and-basic-configuration/ta-p/3131590

[MHM Cisco World]

R#debug standby 

share output of this command after apply to both Router (active and standby)

Thanks A Lot
MHM