Hello,
I want to install IOS on a Cat6509 currently running CatOS. Following are the module and current image details on it. I do not want to retain the config so no need to convert that. I just need to install CatOS. Please advise on what is the procedure as so far the procedures I have come across are to convert it from Hybrid to Native and then from Native to IOS. I am thinking if this should be a straight forward process to just download the IOS image and change the bootvar to use that.
Regards,
Abid Ghufran.
++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Console> (enable) sh module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
2 2 2 1000BaseX Supervisor WS-X6K-SUP2-2GE yes ok
16 2 1 Multilayer Switch Feature WS-F6K-MSFC2 no ok
Mod Sub-Type Sub-Model Sub-Serial Sub-Hw Sub-Sw
---- ----------------------- ------------------- ----------- ------ ------
2 L3 Switching Engine II WS-F6K-PFC2 SAL08186L3X 3.4
++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Console> (enable) dir
-#- -length- -----date/time------ name
1 10807980 Dec 03 2007 18:42:35 cat6000-sup2k9.8-6-3.bin
20791748 bytes available (11189820 bytes used)
++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Console> (enable) sh boot
BOOT variable = bootflash:cat6000-sup2k9.8-6-3.bin,1;
++++++++++++++++++++++++++++++++++++++++++++++++++++++++
