06-06-2013 11:27 PM - edited 03-07-2019 01:46 PM
Hi Everyone,
After upgraded Cisco 3750G switches to IOS Version 122-55.SE7, the output of "show env all" showing the built-in power is unavailable. If we remove RPS, the switches show built-in is good, see the output below. I wonder has anyone seen this? It looks like a bug to me.
Disconnect RPS: .............................................
Cisco3750G-01#sh env all
FAN is OK
TEMPERATURE is OK
Temperature Value: 32 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 55 Degree Celsius
Red Threshold : 65 Degree Celsius
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1 Built-in Good
SW Status RPS Name RPS Serial# RPS Port#
-- ------------- ---------------- ----------- ---------
1 Not Present <>
RPS Connected: ..............................................
Cisco3750G-01#sh env all
FAN is OK
TEMPERATURE is OK
Temperature Value: 32 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 55 Degree Celsius
Red Threshold : 65 Degree Celsius
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1 Built-in Unavail
SW Status RPS Name RPS Serial# RPS Port#
-- ------------- ---------------- ----------- ---------
1 Active <>
Thank you..
06-07-2013 05:42 AM
Hi,
It could be a bug, because even when the RPS is disconnected, the output is not correct.
It should show something like this:
Try a different version and test again.
c3750#sh env all
FAN 1 is OK
FAN 2 is OK
FAN PS-1 is OK
FAN PS-2 is OK
SYSTEM TEMPERATURE is OK
System Temperature Value: 23 Degree Celsius
System Temperature State: GREEN
Yellow Threshold : 46 Degree Celsius
Red Threshold : 60 Degree Celsius
SW PID Serial# Status Sys Pwr PoE Pwr Watts
--- ------------------ ---------- --------------- ------- ------- -----
1A C3KX-PWR-350WAC xxxxxxxxxxxx OK Good Good 350/0
1B C3KX-PWR-350WAC xxxxxxxxxxxx OK Good Good 350/0
SW Status RPS Name RPS Serial# RPS Port#
-- ------------- ---------------- ----------- ---------
1 Not Present <>
c3750#
07-29-2013 05:48 AM
Hi,
I have the same behavior on C2960S-48TS-L and C2960S-24TS-L running 12.2(58)SE2.
.
One connected to a RPS is showing
GSFRDCE-SW091#sh env power
SW PID Serial# Status Sys Pwr PoE Pwr Watts
--- ------------------ ---------- --------------- ------- ------- -----
1 Built-in Unavail
And another one without RPS is showing :
GSFRDCQ-SW091#sh env power
SW PID Serial# Status Sys Pwr PoE Pwr Watts
--- ------------------ ---------- --------------- ------- ------- -----
1 Built-in Good
Regards,
10-04-2021 12:17 AM
Hi
Did anyone find some solution. i have the same issue on WS-C2960S-48TS-L with 152-2.E8
br
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide