ios commands

[suthomas1]

Experts,

some Cat os ouputs need to be used in IOS. It would be of great help if any experts can help with equivalent output in ios for below commands.

set qos map 2q2t tx 2 1 cos 1

set qos drop-threshold 2q2t tx queue 1 200 200

set qos map 1p1q4t rx 1 3 cos 1

set qos wred 1p2q2t tx queue 1 80:100 80:100

set spantree portinstancecost 1/1  cost 1222222 mst

thanks in advance.

[andre.ortega]

You can try use Cisco EDI CatOS to IOS Configuration Conversion Tool. See the link:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a0080816fbc.shtml

[sdheer · Accepted solution]

Hi,

Please find the below doc for all commands for qos commands in IOS.

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/qos.html

For spanning tree :

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.1E/native/configuration/guide/spantree.html

Hope that helps.

Regards,

Swati

Please rate if you find content useful

[suthomas1]

thank you.

if a new 4500 were to be configured & later installed in a production area replacing an older switch acting as coreswitch, will spanning tree cause any impact.

the configurations will be exactly replicated with changes in commands based on earlier links.

edge switches will remain as it is before. only the new 4500 will be installed to act as core replacing the old core. any precautions to be take note of.

appreciate all help.

[andre.ortega]

If you use same configuration (migration command only) will work.