Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello All- We will be bringing up a second 6500 in our core for redundancy. Both 6500s have identical hardware and software; redundant SUP720s (WS-SUP720-3B) and a FWSM. We will also be upgrading the IOS on both as we would like to implement HSRP v2....

I have read many resources about VTP and not found an answer to some questions because often the informations seem inconsistent.First questionIt is not clear if "advertisement requests" are sent only from clients or also from servers.Second questionI...

i have one 3750 series layer 3 switch & 4 vlans configured on it as follows :Vlan 1vlan 2vlan 3vlan 4I want communication between vlan 2 & vlan 3 rest of others shud not be communicate with each other so,when i put "ip routing" is that all other vlan...

I have a 3560 and 3550 Catalyst switches on version 12.2 IOS.  I have one of the switches (Switch 1) with IPSERVICES for the IOS and the rest with IPBASE.  On the Services switch I have PIM sparse-mode configured for VLAN 1interface Vlan1 ip address ...

tnotter by Level 1
  • 1300 Views
  • 1 replies
  • 0 Helpful votes

HiIs it doable to forward VLAN 4 over a WAN Link in my scenario.My requirement is to have one PC in S2 to be on VLAN 4 and use IP 192.168.4.25S1 -------------------- S2S1 connects to S2 over Private circuitOSPF is the routing protocol****************...

Hi Expert,we  created one vlan 72 & SVI 72 (ip 172.26.72.252) on 6509 switch . we have connected 3750 switches to that 6509 switch using trunk.There is no access-list applied to vlan , also windows firewall is also off. we are not able to ping any pc...

I was reading many informations about checksum and CRC.I am a little surprised now because we always read that TCP is reliable, but this is not so true.Do you know any resources where this problem, concerning TCP in particular, is considered?Thanks.

HiI'm planning to get a new switch in order to share 1 or more DSL  uplinks between a set of neighbours, and I'd like to know if it is doable, and which switch should I choose for it.So.. take a look at this:http://img375.imageshack.us/img375/5691/es...

Mamonetti by Level 1
  • 822 Views
  • 3 replies
  • 0 Helpful votes

HelloIn my scenario Core and Distribution is the same switch and we got a trunk to the Access-Switch. As we are growing we plan to have a distribution switch. what configuration goes on distribution switch.Core is in VTP mode server and all Access-Sw...