Hi.
Does anyone know of any compatability issues when configuring an iSCSI node on a HP P4500 connecting to a FEX as a vPC on a pair of 5K's?
The LAG ID's are different on the incoming links from the SAN node:
cam-dat-asw-sfy-01# sh vpc consistency-parameters vp 8
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name Type Local Value Peer Value
------------- ---- ---------------------- -----------------------
Shut Lan 1 No No
STP Port Type 1 Default Default
STP Port Guard 1 None None
STP MST Simulate PVST 1 Default Default
lag-id 1 [(7f9b, [(7f9b,
0-23-4-ee-be-1, 8008, 0-23-4-ee-be-1, 8008,
0, 0), (ffff, 0, 0), (ffff,
9c-8e-99-19-3e-7a, 11, 9c-8e-99-19-3e-7a, 9,
0, 0)] 0, 0)]
mode 1 active active
Speed 1 1000 Mb/s 1000 Mb/s
Duplex 1 full full
Port Mode 1 access access
MTU 1 1500 1500
Admin port mode 1
Allowed VLANs - 208 208
Local suspended VLANs - - -
++++++++++++++++++++++++++++++++++++++++++++++++++++
8 Po8 up failed vpc port channel 208
mis-config due to vpc
links in the 2 switches
connected to different
++++++++++++++++++++++++++++++++++++++++++++++++++++
I've got vPC working on two physical servers connected to these 5K's and had Cisco confirm the config as ok.
Can anyone help? Has anyone set up vPC connected to a SAN node?
Thanks
Paul
