Learn how to configure VRRP on the Catalyst 3560

[Translator]

How do I use the subject?

Currently, we want to build a VRRP configuration with other companies' devices using Catalyst3560

You can enable ip routing, create an SVI, and assign an IP address on the device.

However, you cannot configure VRRP for SVI

I tried a few commands and found that I can configure HSRP, but can't I configure VRRP?

version is 12.2(37).

In the link below, there was a description that has the function of VRRP, but the specific solution was not described.

https://www.cisco.com/c/ja_jp/td/docs/sw/lanswt-access/cat3560swt/cg/009/swcfg/swhsrp.html#47648

I think it is a fairly rough disclosure, but I want to know whether the VRRP function can be used on the C3560 in a hurry.

Thank you for your patience.

[Translator · Accepted solution]

It is also mentioned in the referenced documentation.
At a minimum, the version that supports VRRP seems to be "12.2(58)SE". (You might also need to consider other things like Feature Sets, but at least they don't meet the version.) )

Catalyst 3560 Switch Software Configuration Guide Cisco IOS Release 15.0(1)SE - Configuring HSRP and VRRP [Cisco Catalyst 3560 Series Switches] - Cisco
https://www.cisco.com/c/ja_jp/td/docs/sw/lanswt-access/cat3560swt/cg/009/swcfg/swhsrp.html
> Cisco IOS Release 12.2(58)SE supports the virtual router redundancy protocol (VRRP) for IPv4 and IPv6.

Release Notes for the Catalyst 3750, 3560, 2960-S, and 2960 Switches, Cisco IOS Release 12.2(58)SE1 and Later - Cisco
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750/software/release/12-2_58_se/release/notes/OL24337.html
[Excerpt Part of Table]
| Feature            | Minimum Cisco IOS Release Required | Catalyst Switch Support |
| VRRP for IPv4 | 12.2(58)SE1                                        | 3750,3560                   |

Look at the Configuration Guide.
In your 12.2(37), you can only use HSRP.

Catalyst 3560 Switch Software Configuration Guide, Rel. 12.2(37)SE - Configuring HSRP [Cisco Catalyst 3560 Series Switches] - Cisco
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_37_se/configuration/guide/3560scg/swhsrp.html

12.2(58)SE also shows the HSRP and VRRP chapters.

Catalyst 3560 Software Configuration Guide, Release 12.2(58)SE - Configuring HSRP and VRRP [Cisco Catalyst 3560 Series Switches] - Cisco
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_58_se/configuration/guide/3560scg/swhsrp.html

[Translator]

Thank you for your kind response and evidence.

I understand it's a Version issue.

We will consider once the answer is received.

I would like to thank you again for your quick response.