Limitation of vlan number in route-map

[tnn-dray]

Dear community , 

i have question relevant tovlans  limitation  number under route-map is limited to 32vlans? 

we encoutered this issue  on Nexus OS 7K ( 8.2.1) by adding new vlan in the route-map configuration  (below error by adding new vlan)

% Cannot add - exceeding maximum limit of 32 entries per command

any one have the similar issue please ? 

Thank you

[paul driver]

Hello what are you try to accomplish when you say adding multiple vlans under a route-map?

[tnn-dray]

Add new vlan under route-map (which is limited to 32vlans) 

[paul driver]

Hello

I understand that but why do you need to add multiple vlans to a route-map what is the route map being used for

[tnn-dray · Accepted solution]

Hello 

i got confirmation from cisco TAC:  the limitation is 32entries per sequence

the solution :  add new sequence attached to same route-map

Thank you for your help 

[tnn-dray · Accepted solution]

here an exemple : 

switch(config)# route-map MAP permit 1

Switch(config-route-map)# match interface Vlan300

% Cannot add - exceeding maximum limit of 32 entries per command

[mlund]

Hi

I don't know if this is possible, but you can try to do a range like vlan 200-300.

/mikael

[tnn-dray]

Hi

Thank you for your feedback, we use random vlan and we don't have any range to be sepcified

i think new bug because it was not mentionned  in PBR limitation guidline : Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide - Configuring Policy-Based Routing [Cisco Nexus 7000 Series Switches] - Cisco

BR