Hello, I am doing a university project about creating a network for 2 buildings and connect eachother through router relay (also DHCP). Each building as different vlans, but I already tried a bunch of times and It didn't worked...the DHCP Server is c...
I have SSH access to a WS-6504-E and have been told to wipe it and factory reset it. I'm familiar with the procedure for wiping regular access switches but this switch looks like potentially a lot more complicated to wipe. I'm not familar with thes...
Hi Folks, Hope you are all safe and vaccinated, I have this question long time. why we are preferring routers than a switch as L3 switches also do routing. What are the scenarios where we can use L3 switch instead of router with protocols like bgp...
I need to add a new switch to an existing 9200L stack, can I add this switch without having to reconfigure the stack ??? Can I add an additional switch to a Stack 9200L without shutting down and without rebooting? Greetings.-------------------------...
If a vlan is not configured as an access vlan for any of the interfaces and there are 3 trunk interfaces, will this vlan traffic go out to all 3 trunk interfaces? Eg:L3 switch 1vlan 100ip address 111.10.122.2 255.255.255.0 L3 switch 2vlan 100ip addre...
Hi all,I have a 3750 on my desk which I’m using for new site, I removed this from a previous stack of 4 configuration.I ran the no switch 4 provision ws-c3750g-24ts on the stack after I powered it down and removed it. (no problems it was switch 4)I t...
Hi all, I have a multicast new IPTV configuration on a catalyst 9k platform and seeing hundreds of megabits of traffic on the uplinks which I think it should not be there. The streams are good and the TVs are working normally but the unnecessary traf...
I have a solution the customer need a modular core c9606R and the edge switches are Meraki MS225 stackable.the problems is : the transceivers supported by C9606R (SFP-10G-LR) are not compatible with MS225 (MA-SFP-10GBLR)IF I installed SFP-10G-LR on ...
Hello, I have setup the routing as well and the VPN tunneling too. Vlans has been configured in switches with vtp server and client but still is not working.
Hi.I ask for help following the previous question.The configuration diagram is as follows.vlan 10 data -> 2.2.2.0/24vlan 10 voice -> 1.1.1.0/24I am trying to apply auto qos.L3: C3850L2: C1000IP Phone: avaya IP Phone I entered the following through th...
Do Cisco switches (all models) use the 1998 standard root port cost for configuration of root port, or the 2004 standard root port cost?
Hi. I have configured my multilayer switch that is connected to a router thats running IPS, but for some reason my syslog wont react and add the logs. I dony know what i am doing wrong. Please help? this is in cisco packet tracer, please help i have ...
Trying to perform packet tracer activity 2.1.1.5. Perform all the steps twice, but coundn't complete last step where i need to configure server (which is connected to cloud) because services tab is not there only these tabs are available Physical, C...
For the 9500-16x cluster, do you need to trunk the VLANs across those SVLs? Or that is taken care of already automatically. I have a few VLANs and SVIs configured, but I am assuming no need to add the SVLs in the trunk? Any assistance is greatly appr...
HiWhere can i find the visio stencil for Cisco 6506-E FourX Adapter for 10 Gigabit Ethernet Mode. I found the WS-X6904-40G-2T module but I unable to find the FourX 10G Adapter for it.Thanks in advance,Martin John
