01-30-2024 05:28 AM
I mistakenly configured line vty Login local in my cisco switch without username but when i try to login the switch through telnet its asking username password tried CISCO, ADMIN but nothing works so please help what is the solution to login the switch Via telnet.
01-30-2024 05:32 AM
Hello @Rajesh
Log with console port and modify your line vty config.
01-30-2024 05:34 AM
try using Console
then add
username xxx password xxx
enable password xxxx <- this mandatory
01-30-2024 05:47 AM - edited 01-30-2024 07:36 AM
Hello @Rajesh ,
if what M02@rt37 and @MHM Cisco World doesn't work in your situation, you can do a password recovery on the router. This procedure will place you in enable mode which gives you the chance to change usernames and passwords.
You can find a step by step procedure here: https://community.cisco.com/t5/networking-knowledge-base/password-recovery/ta-p/3123097
01-30-2024 05:49 AM
Hello @Rajesh ,
if you haven't saved the change have someone to reboot the switch.
if you have saved the change you need to connect to the console as explained by M02@rt37 and @MHM Cisco World
The issue is caused because no username exists
Hope to help
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide