I'm running a 6506 switch that ran into a memory leak issue causing it to deny access to NVRAM. The obvious answre from TAC was to upgrade the switch to a new version of the same train. The problem is I don't have access to NVRAM, so I can't save the config. I wanted to make the switch pull the config from other location (TFTP or flash) after the reboot using confreg, but unfortunately I couldn't find the confreg that would do that.
That's not exactly what I'm looking for. There's a good chance I'm not going to have console access to the switch, so any manipulations in ROMMON are not an option. I need to do it using confreg setting only.
On 18th December 2020, Cisco announced the latest IOS XE release - Cisco IOS XE Bengaluru 17.4.1a
The first one in the Cisco IOS XE Bengaluru release series, IOS XE 17.4.1a unlocks various routing features and enhancements comprehensively c...
This event had place on Tuesday 19th, January 2021 at 10hrs PDT
In this session attendees received an introduction to Software Defined-WAN (SD-WAN) and the importance of control connections, and learn how to configure devices us...
(view in My Videos)
Community Live- May the SD-WAN Force Be With You
This event took place on Tuesday 19th, January 2021 at 10:00hrs PDT
In this session attendees received an introduction to Software Defined-WAN (SD-WAN) and the importance of ...
Cisco Champion Radio · S8|E3 The Cisco DNA Center Machine Reasoning Engine
Machine Reasoning is a new category of AI/ML that you will soon hear a lot about. It saves your IT team time by automating complex and tedious networking tasks. It can also...
To participate in this event, please use the button to ask your questions
In this session attendees will receive an introduction to Software Defined-WAN (SD-WAN) and the importance of control connections, and learn how to configure devices usi...