Hello all,
Another newbie here.
I am very new to the world of the mystical computer. I am currently studying for my ccent and I am using some instructor prepared practice tests. I have hit a bit of a wall on a few of the questions and would greatly appreciate some help. I will start with the easer of the two.
#1. which of the folllowing commands are interface defaults in a cisco switch
a. switdhport mode access
b .switchport port-security
c. switchport port-security mac-address sticky
d. switchport port-security max 1
e. switchport portsecurity violation restrict
f. no shutdown
I know that f is a default, butt I am a little lost on the other?
#2. What is a reason to not use the logging synchronous command?
a. to see debug messages
b. to see buffer log messages
c. to see logs a debugs during a reload
d. to see log and debugs during a ping
I know that the logging synchronous command will prevent interruptions in typing. however I am not familiar enough with debugs and troubleshooting to know when you would want to be interrupted?
I would appreciate any guidance that can be offered in answering these questions
Thank you
