10-29-2015 01:24 PM - edited 03-08-2019 02:29 AM
I have an issue with my FEX that I hope someone can help with.
I created a channel group and then went in to assign ports to the channel group on the FEX. I was able to put one interface in the channel group but when adding the next one I got this error:
Command failed: port not compatible [Max members on FEX exceeded ]
I only have 10 ports active on the FEX and only 1 channel group (the one I created) on it as well. So why is it that this error is popping up?
Thanks in advance.
10-29-2015 01:35 PM
What is the parent switch you are connecting to?
How many FEXs are already connected to the parent switche?
10-29-2015 08:59 PM
Parent is 2 dual homed 5548s, have 6 FEXs attached to them but very few channel groups and interfaces assigned to them. Both of these are configured exactly the same.
4x2148 FEX (2 of them are the 2 I'm configuring and have the error with above)
2x2248 FEX
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide