04-27-2017 07:57 AM - edited 03-08-2019 10:21 AM
Hello, I have the following situation:
1. Network1: 192.168.1.0/24 gateway 192.168.1.2
2. Netwotk2: 192.168.2.0/24 gateway 192.168.2.2
3. Network3: 192.168.3.0/24 gateway 192.168.3.2
4. Linux box with the inside NIC with 3 interfaces: 192.168.1.2/24, 192.168.2.2/24, 192.168.3.2/24
5. Switch1 connected to the Linux box
6. Switch2 connected to switch 1 via RJ45
7. Switch3 connected to switch 2 via RJ45
8. 10 Other switches connected in different ways
9. All switches have a mix of networks, so there is no physical segregation of networks/switches.
I am tasked with replacing the Linux with an ASA5506. The only reason the current setup has 3 networks is because they ran out of IP's on network1.
I tested configuring the inside interface on the ASA with a 192.168.1.2/22 network and changing the configuration on two PC's on network1 to 192.168.1.100/22 with gateway 192.168.1.2 and 192.168.1.101/22 with gateway 192.168.1.2 and I get a good ping if both PC's are on the same switch. However, when I test from a 3rd PC with a similar config on switch2 or switch3 the ping intermittently fails.
Can I configure 3 interfaces on the ASA?
What alternatives do I have to accomplish this task?
04-27-2017 12:50 PM
Hello,
is it an ASA 5506X ? If that is the case, it has 8 layer 3 GigabitEthernet interfaces.
Can you post the config you have so far ?
04-28-2017 05:22 AM
Thank you Georg for your reply. Yes, it's an ASA 5506X. I currently don't have access to connect to it so I won't be able to get the config. What I've tried is the following setup that didn't work.
Setup:
I configured the ASA's inside interface (port 2) with IP 192.168.1.2 and mask 255.255.248.0, connected this port to the switch, but as explained above I get ping failures between hosts in the network.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide