04-09-2013 11:16 AM - edited 03-07-2019 12:43 PM
Hi !
I have been reading some extra information about monitor sessions (SPAN) and I just want to confirm if monitor session can be identified by ''name'' additionally to his ''SPAN session number''.
This is because my customer wants to identify monitor sessions by ''a name'' instead of ''a number''...
Is that possible?
Regards,
guruiz
04-09-2013 12:24 PM
Hello guruiz,
I have not seen anywhere where cisco have stated that you can use a 'name' - its always been a numerical value.
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015c612.shtml
Of what I have seen, the syntax has remained:
'monitor session session_number ......'
Hope this helps.
Please rate useful posts and remember to mark any solved questions as answered. Thank you.
04-09-2013 01:24 PM
Thanks Bilal,
I was almost sure about that. Now, due your kind answer, I am sure that I can't configure a specific name to a monitor session (so far......).
Thanks again.
guruiz
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: