Multiple Serial Links - Source Destination Pair

[cisco_lite]

If I define static routes over two serial links connected to a single router, how can I check which source/destination pair is utilizing which serial link. With static routes, the traffic will be load balanced across the serial link.

Thanks.

[Giuseppe Larosa]

Hello Cisco_Lite,

that HSRP config should work I used it some years ago.

I might have done some syntax errors because I wrote the commands on the post without searching an old config.

>> is ip load-sharing per packet (on serials) supported in HSRP configuration or is it completely independent of HSRP/GLBP etc.

it is indipendent

Hope to help

Giuseppe