Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Ask Me Anything Event   Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from  Monday, November 4, 2024 through Friday, November 15, 2024. Our colleagues Rohit Chopra, Vaibhav Aggarwal, Anuraag Majumdar, Saquib Zeya...

rohit.png Vaibhav Aggarwal.png anuu.png Saquib Zeya.png

in the video datasheet,4928-10G is introduced to be used in the collapsed distribution/core.but i have some questions:1 what's the requirement of the collapsed distribution/core layer,i noticed that the full line rate is one requirement ,but is there...

referinfo by Level 1
  • 1480 Views
  • 3 replies
  • 0 Helpful votes

Hi,i set up inter vlan routing with dell switch.I was able to ping hosts in vlan 10 from a host in vlan 30 but host in vlan 10 can not ping host in vlan 30Does somebody understand this ? Help.Here is the attached config.

kolawole1 by Level 1
  • 1213 Views
  • 3 replies
  • 0 Helpful votes

Error was seen from CISCO6506.%PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 2 is experiencing the following error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000) Module 2 is WS-X6148-GE-TXBut all ports and protocols are running well all the ti...

Resolved! 3560 Redundancy

Hi Guys,I have a new 2x 3560, do you have any suggestion on how can I make this redundant? Like you will just see 1 node for this two switches. I have configured an etherchannel on it but it seems it is not working. interface GigabitEthernet0/1 chann...

Resolved! rstp edge port

Hi every body!My cisco press book says if edge port receives a bpdu, it loses its status.The question is what do we mean by that?Does it mean the the port transitions into forwarding state?thanks a lot!

sarahr202 by Level 5
  • 1042 Views
  • 1 replies
  • 0 Helpful votes

Resolved! rootguard feature

Hi every body!I find in chapter 4 of cisco press book that by default cisco switch detect all the following causes among others and put the port in erridisable state if it finds any:rootguard,loopguard,bpduguard. etcOnce the port is in errdisable st...

sarahr202 by Level 5
  • 423 Views
  • 2 replies
  • 0 Helpful votes

Hi I am experiencing a strange issue with the DHCP feature on the Cisco 3560 switch ( IOS 12.2(46) ). If we reboot the Cisco 3560 switch DHCP Option 176 ascii string will be get added to another double colon. Hence Avaya IP Phones fails to regist...

Review Cisco Networking for a $25 gift card