NAT Setup

[jheatherington]

I need some help with setting up NAT on my cisco router. I know how to add port forwarding, eg. ip nat inside source etc... . My question is how do I remove this line or how do I change this line.

Thanks

Jeremy

[mohammedmahmoud]

hi Jeremy,

You need to clear the NAT translation table first, kindly use "clear ip nat translation *" command.

HTH,

Mohammed Mahmoud.

[jheatherington]

Does this clear all entries in the nat translation table, and then you have to re-enter them all. Just making sure so that I don't forget to readd some.

Thanks

Jeremy

[mohammedmahmoud]

Hi Jeremy,

No this is required only if you are doing dynamic NAT, please do check this document:

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094422.shtml

HTH,

Mohammed Mahmoud.

[jheatherington]

Thank you for your help

Jeremy

[mohammedmahmoud]

Jeremy,

You are very welcomed, have a nice day :)

HTH,

Mohammed Mahmoud.