Solved: NAT

jonk34567 · ‎12-21-2017

In "show ip nat translations " coomand does it show the result only if we ping a outside address ?

Karsten Iwen · ‎12-22-2017

It shows all translations that are in the translation-table:

Static translations are always in the table and are always shown
Dynamic translations only show up when triggered by traffic.

View solution in original post

Karsten Iwen · ‎12-22-2017

It shows all translations that are in the translation-table:

Static translations are always in the table and are always shown
Dynamic translations only show up when triggered by traffic.

paul driver · ‎12-22-2017

Hello

Just like to add to Karsten comments , this would also apply to Domain-less/NVI NAT

show ip nat nvi translations

res
Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Julio E. Moisa · ‎12-22-2017

Hi

No, it will show every translation executed by the NAT, including (PAT) tcp, udp, etc.

>> Marcar como útil o contestado, si la respuesta resolvió la duda, esto ayuda a futuras consultas de otros miembros de la comunidad. <<