05-03-2010 09:31 AM - edited 03-06-2019 10:54 AM
Hi ,
I need to perform dynamic natting based on destination ip address , Similary let me know whether i can have multiple dynamic natting in cisco router .
In my setup i need to use mutiple dynamic nat becoz client has given access to the apllication server based on my NAT IP address pool ..
pasting u sample config
interface FastEthernet0/1
ip address 172.16.1.1 255.255.255.0
ip nat inside
!
interface Serial0/0/0
ip address 10.10.10.2 255.255.255.252
ip nat outside
!
!
ip nat pool dev 10.10.10.9 10.10.10.11 netmask 255.255.255.252
ip nat pool prod 10.10.10.12 10.10.10.15 netmask 255.255.255.252
ip nat inside source list 101 pool dev
ip nat inside source list 102 pool prod
ip classless
!
!
access-list 101 permit ip 172.16.1.0 0.0.0.255 host 20.20.20.1
access-list 102 permit ip 172.21.16.0 0.0.0.255 host 30.30.30.1
If am wrong in my commands please write back ..thank you..
Solved! Go to Solution.
05-03-2010 09:52 AM
Yes you can have multiple NAT pools on IOS and your config looks fine. Have you tested it yet ?
Jon
05-03-2010 09:52 AM
Yes you can have multiple NAT pools on IOS and your config looks fine. Have you tested it yet ?
Jon
05-03-2010 10:02 AM
Thanx Jon much , I havent tested , prepared config from lab router ..once i have tested i ll let you know ..
I am always impressive with your answer which u used explain with clear concept n fundas , keep rocking !!!!!!!!!!!!!!!!!!!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide