Need help! Serious problem with Cisco ME 3400 Switch

[hardy]

Hi everyone!

I have Cisco ME 3400 Switch that stopped working, when i tryed to connect to the console via Console Cable all i can get is this below. 

- System lamp blinks constantly *from start. 

- all 24 ports indicator lamps + 2 FSP ports lights up first Orange then Green about 5 sec and they turns off later. 

- and that's it. 

I wonder if you guys know what is the problem with my switch.  

 

here is a short clip of it. 

https://youtu.be/fUVAF8fRmDc

[Leo Laohoo]

- System lamp blinks constantly 

Sounds like a dead switch. 

Have you tried changing to a different baud rate of the console terminal?

[hardy]

hope not! 

I have been testing 110, 300, 600, 1200, 2400, 4800, 9600 and 14400. 

here is a short clip of it. 

https://youtu.be/fUVAF8fRmDc

[Julio E. Moisa]

Hi

Is the same output if you go into rommon mode? otherwise you could try using this command:

rommon:1:flash_init
rommon2#set BAUD 9600
rommon3#reset

Please see the following link, It could be useful (without remove any file)

https://supportforums.cisco.com/discussion/11391726/3750-recovery-baud-setting