cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

430
Views
0
Helpful
0
Replies
Highlighted
Beginner

Nexus 7K - MAC table not displaying

Hi,

Working with Nexus 7k with NX-OS 6.0(1) code.  There are no ACLs for L2/L3 traffic nor port security in this scenario.  I have two (2) VDCs running and on one VDC when I issue the show mac address-table command with the dynamic, interface command options I get no results, the table freezes at the following:

Legend:

        * - primary entry, G - Gateway MAC, (R) - Routed MAC, O - Overlay MAC

        age - seconds since last seen,+ - primary entry using vPC Peer-Link

   VLAN     MAC Address      Type      age     Secure NTFY Ports/SWID.SSID.LID

---------+-----------------+--------+---------+------+----+------------------

I have to issue a Ctrl+C to break out of this.

On the other VDC this does not seem to be an issue and I get a table of output.

When issuing a clear mac address-table dynamic,  the prompt also freezes until a Ctrl+C is issued.

Any ideas are greatly apprciated.

CreatePlease to create content
Content for Community-Ad