Does anyone know if the HSRP for 7018s/7010s required an authentication? I have not configured authentication on my SVI, but the "sh hsrp" shows text authentication of "cisco".
Vlan2 - Group 1 (HSRP-V1) (IPv4)
Local state is Initial(Interface Down), priority 20 (Cfged 20), may preempt
Forwarding threshold(for VPC), lower: 1 upper: 20
Preemption Delay (Seconds) Minimum:180
Hellotime 3 sec, holdtime 10 sec
Virtual IP address is 10.32.32.1 (Cfged)
Active router is unknown
Standby router is unknown
Authentication text "cisco"
Virtual mac address is 0000.0c07.ac01 (Default MAC)
3 state changes, last state change 2d22h
IP redundancy name is hsrp-Vlan2-1 (default)