Hello community,
I'm trying to do selective QinQ in interfaces.
Following the configuration guide here , in the section "Configuring Selective Q-in-Q with Multiple provider VLANs"
we see that this should be possible.
When I try to configure the second entry of vlan mapping I get:
"ERROR: Eth1/3 : Conflicting vlan mapping dot1q-tunnel configuration on port(s) exists"
This port is a member of an already configured port-channel, and I'm entering the commands in the port-channel interface that are then correctly replicated to the interface.
I've tried also in a non port-channel interface, and same happens.
This is a 93180YC-EX switch with following software:
Software
BIOS: version 07.65
NXOS: version 7.0(3)I7(4)
BIOS compile time: 09/04/2018
NXOS image file is: bootflash:///nxos.7.0.3.I7.4.bin
NXOS compile time: 6/14/2018 2:00:00 [06/14/2018 09:49:04]
Do you have any clue why this is rejected?
Thank you.