cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
553
Views
0
Helpful
3
Replies

nme-xd-48es-2s-p module has no interface in the CLI

clacsa001
Level 1
Level 1

hi good day i have a cisco 3825 integrated service router and it has "c3825-ipbasek9-mz.124-24.T3.bin". I need help it says in the show diag i have slot 2 as nme-xd-48es-2s-p, But i can't see it on the CLI or in show ip interface brief thank you in advance

3 Replies 3

Richard Burts
Hall of Fame
Hall of Fame

You use the connect command to access the service module and then to configure it. See this link for details about how to configure this Service Module

http://www.cisco.com/c/en/us/td/docs/ios/12_4t/12_4t2/serdescn.html#wp1066995

 

HTH

 

Rick

 

 

HTH

Rick

You use the connect command to access the service module and then to configure it. See this link for details about how to configure this Service Module

http://www.cisco.com/c/en/us/td/docs/ios/12_4t/12_4t2/serdescn.html#wp1066995

 

HTH

 

Rick

 

Thank you i will try it and post again if it doesn't work 

clacsa001
Level 1
Level 1

Hello i have access the module using service-module gigabitEthernet 2/0 session but im stuck on 
 

switch:

 

and i also got an error


switch: usb 3-1: device descriptor read/all, error 12

 

i was following this guide

http://www.cisco.com/c/en/us/support/docs/interfaces-modules/network-modules/82288-es-mod-config.html#step1