No counter on Nexus 7K when enter command "Show interace vlan XXX "

[Hele Du]

Hi all,

There is no counter on interface vlan 999 on nexus 7K.

Is there have some workarounds to fix this ?

As far as I know on Catalyst 6500 or 4500 there is a counters command under interface Vlan, does nexus 7000 have some function?

Vlan999 is up, line protocol is up, autostate enabled
  Hardware is EtherSVI, address is  e8ed.f324.4342
  Internet Address is 192.168.200.118/30
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
   reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive not supported
  ARP type: ARPA
  Last clearing of "show interface" counters never
  60 seconds input rate 0 bits/sec, 0 packets/sec
  60 seconds output rate 0 bits/sec, 0 packets/sec
  Load-Interval #2: 5 minute (300 seconds)
    input rate 0 bps, 0 pps; output rate 0 bps, 0 pps
  L3 Switched:
    input: 0 pkts, 0 bytes - output: 0 pkts, 0 bytes
  L3 in Switched:
    ucast: 0 pkts, 0 bytes - mcast: 0 pkts, 0 bytes
  L3 out Switched:
    ucast: 0 pkts, 0 bytes - mcast: 0 pkts, 0 bytes

[Hele Du]

Hi Bilal,

The "show ip interface vlan 999" output is below:

IP Interface Status for VRF "default"(1)
Vlan999, Interface status: protocol-up/link-up/admin-up, iod: 39,
  IP address: 192.168.200.117, IP subnet: 192.168.200.116/30
  IP broadcast address: 255.255.255.255
  IP multicast groups locally joined:
      224.0.0.6  224.0.0.5  
  IP MTU: 1500 bytes (using link MTU)
  IP primary address route-preference: 0, tag: 0
  IP proxy ARP : disabled
  IP Local Proxy ARP : disabled
  IP multicast routing: disabled
  IP icmp redirects: enabled
  IP directed-broadcast: disabled
  IP Forwarding: disabled
  IP icmp unreachables (except port): disabled
  IP icmp port-unreachable: enabled
  IP unicast reverse path forwarding: none
  IP load sharing: none
  IP interface statistics last reset: never
  IP interface software stats: (sent/received/forwarded/originated/consumed)
    Unicast packets    : 30284334/164582/6407/30278041/229173
    Unicast bytes      : 3504189678/17123919/2083262/3502113589/18144009
    Multicast packets  : 2186804/2111650/0/2186804/2111650
    Multicast bytes    : 244076832/184634912/0/244076832/184634912
    Broadcast packets  : 0/0/0/0/0
    Broadcast bytes    : 0/0/0/0/0
    Labeled packets    : 0/0/0/0/0
    Labeled bytes      : 0/0/0/0/0
  WCCP Redirect outbound: disabled
  WCCP Redirect inbound: disabled
  WCCP Redirect exclude: disabled

Does this refer to the software switching?

[Bilal Nawaz]

What about "show ip interface xxxx" ?

[Vinit Jain]

Hello Bilal

it will still not show the counter as its a F2 card

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/6_x/nx-os/release/notes/61_nx-os_release_note.html#pgfId-608434

Per vlan statistics are not supported on this card.

the VDC type is F2, F2e so in which case, i think the F2e only capabilities have been disabled i.e. the SVI statistics

F2e

F2,F2e

Yes

Disables F2e-only capabilities like SVI statistics.

You will lose only the F2e configuration.