Hi ALL:
I see the last input and 30 sencond input and output as 0.
What my understandinig is since CEF is enabled the packet are not hitting the CPU and thats why i dont see any input and output.
Is that right or i am missing something.
This is 4507r with Sup V-10GE .
GigabitEthernet7/16 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet Port, address is 001f.9e46.a67f (bia 001f.9e46.a67f)
Internet address is x.x.x.x
MTU 1500 bytes, BW 4096 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000-TX
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
L3 in Switched: ucast: 488526834 pkt, 57240662759 bytes - mcast: 0 pkt, 0 bytes
L3 out Switched: ucast: 530401074 pkt, 374322172171 bytes - mcast: 0 pkt, 0 bytes
488561771 packets input, 67080948138 bytes, 0 no buffer
Received 34128 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
530439677 packets output, 384140361152 bytes, 0 underruns
101 output errors, 15 collisions, 0 interface resets
0 babbles, 101 late collision, 0 deferred
0 lost carrier, 0 no carrier
Chao
Vishwa
