05-18-2007 01:22 AM - edited 03-05-2019 04:09 PM
I have a Cisco Catalyst 4507R with two Sup-Engine V-10GE.
When I remove from the chassis the active SUP-Engine, the switchover works fine, but there is no syslog message on the LMS syslog.
When I re-insert the module in the chassis, syslog messages appeared well on LMS syslog (module inserted).
The IOS is: 12.2(31)SGA1
the config is:
logging 172.30.7.240
!
snmp-server community fread RO
snmp-server community fwrite RW
snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart
snmp-server host 172.30.7.240 f1matread
05-18-2007 03:02 AM
Hi Friend,
Can you configure these 2 commands and update the status
snmp-server enable traps entity
snmp-server enable traps fru-ctrl
Regards,
Ankur
05-19-2007 12:09 AM
The problem is not resolved.
The logs that appear on the Cat4507R console are:
May 18 06:58:22.902: %C4K_IOSMODPORTMAN-6-MODULEOFFLINE: Module 2 is offline
May 18 06:58:23.906: %C4K_IOSMODPORTMAN-6-MODULEREMOVED: Module 2 is removed
But thez don't appear on the LMS Syslog.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: