03-04-2010 08:36 PM - edited 03-06-2019 10:00 AM
Hi,
How to disable NTP Server Detection on a switch / router? Even configuring the NTP settings as peer.
Scan detecs NTP
GV
03-04-2010 10:20 PM
Hi,
How to disable NTP Server Detection on a switch / router? Even configuring the NTP settings as peer.
Scan detecs NTP
GV
Hi GV,
If you want to disable a NTP services in specific interface then you can try with the following configuration
interface interface-id
ntp disable
Disable NTP packets from being received on the interface.By default, all interfaces receive NTP packets. Hope to Help !!
Remember to rate the helpful post !!
Ganesh.H
03-04-2010 11:04 PM
Hi,
Your suggestion not solving my problem. I am making my switch NTP configuration pointing to my peer (x.x.x.x).
But still NTP service running on my switch, how to solve this
03-04-2010 11:16 PM
Hi,
Your suggestion not solving my problem. I am making my switch NTP configuration pointing to my peer (x.x.x.x).
But still NTP service running on my switch, how to solve this
To terminate NTP service on a device, you must enter the no ntp command without keywords.
Check out the below link hope to help !!
http://www.cisco.com/en/US/docs/ios/12_2/configfun/command/reference/frf012.html#wp1123354
Ganesh.H
03-04-2010 11:24 PM
Ganesh,
Even after disabling my NTP configurations or by giving no NTP on my switch.
While scanning NTP ports are lestining, i am using nessus scan tool.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide