need some help here. my situation is a bit complicated.
1. i have a few sites which are interconnected.
2. there are multiple mobile sets of equipment(servers and catalyst 3560 switch) which i need to connect at different sites. (i cant use repeated subnets)
3. i cant change the ip address/subnets/configuration of the servers and switch, when deploying at different sites. (big problem to me)
i was previously looking at IP unnumbered + OSPF to apply on the mobile sets of equipment. but noticed that IP unnumbered on non pt-to-pt interrfaces (which happens to be a 3560) does not work with dynamic protocols.
is there any solutions/alternatives which i can achive mobility on equipment?
It just popped in my head; you can create a VLAN for the mobile equipment, then create a SVI with a IP address designated for the mobile equipment. set the ospf to point to that SVI (virtual int) for the mobile set, have ur devices connect through that VLAN and their permanent ip address, using a SVI as gateway.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...