PC Cant catch dhcp

[Malter17]

why can't the pc catch dhcp?
even though my configuration remains the same as usual...
like

For

Switch Config:

No IP domain-lookup
Vlan 10
Name Malter
Exit
Int range fa 0/2-11
Switchport access vlan 10
No sh
Int fa 0/1
Trunk mode switchport

Router Config:

No IP domain-lookup
Int fa 0/1.10
encapsulation dot1Q 10
IP address 192.168.100.1 255.255.255.0
No sh
Exit

btw the switch and router are connected to 1 hub

[MHM Cisco World · Accepted solution]

In router do 

Int fa 0/1

No shut 

Abd check

MHM

[Malter17]

still can't, sir

does switch (fa) to hub (eth)

Does different port type affect it?

[MHM Cisco World]

this is packet tracer lab 
share it here 
there are some engineer excellent and can help you

MHM 

[Malter17]

still can't get DHCP... then my server won't connect either

[MHM Cisco World]

sorry I am busy now 
I hope other will answer you

MHM

[M02@rt37 · Accepted solution]

@Malter17 

On Int fa 0/1.10 add ip helper-address x.x.x.x command 

with x.x.x.x the IP address of your DHCP server.

[Malter17]

Still cant

[M02@rt37 · Accepted solution]

@Malter17 

Check server IP configuration: IP/subnet/Gateway. Does the server ping its Gateway ? Does the server ping 192.168.100.1 ?

[Malter17]

For the server, I think I'll just leave it for now, for the PC that failed to catch DHCP, I'm confused sir...

[M02@rt37 · Accepted solution]

@Malter17 

Different issue on your SW and router configuration !

First on the SW:

Modify FA0/1 2 and 3 like this

Fa0/1 and FA0/2 are access mode because PC are connected!

FA0/3 is a Trunk port !

On the Router:

Modify pool 50 like this:

You have to configure the network command....

PC-16 and 17 should have an IP address:

[Malter17]

it's always like this sir...

[M02@rt37 · Accepted solution]

@Malter17 

The modifications I show you it is only for vlan 50....

so PC-16 and 17 should have an IP if you follow me.

For the others VLAN you have to adjust the configuration ...

[Malter17]

why when I configure the switch

Switch(config)#interface range FastEthernet0/2-13
Switch(config-if-range)#switchport access vlan 30

does the switchport remain in trunk mode?
do I have to do it manually config?

[M02@rt37 · Accepted solution]

@Malter17 

Port connected to PC have to be in switchport mode access with access vlan x command ! x the vlan id.

Port on Switch connected to others Switch or Router have to be in Trunk mode! switchport mode trunk command.