Portfast edge in IE 3000

[MartinNantus11364]

Sorry if this is a stupid question, but...

I've been using IE2000's in an application, and as those aren't available any longer, my company has switched to IE3000 switches.

I was putting the file for one of my IE2000's into the 3000 and it told me that "spanning-tree portfast edge" was invalid at the "edge" portion.

It looks from using "?" after the "portfast" that default is edge. But do I actually put "default" there?  Or just leave it blank after "portfast" so that by default it's edge?

I'm somewhat confused is all...

Thanks!

[Mark Elsen]

  - @MartinNantus11364         Ref : https://www.cisco.com/c/en/us/td/docs/switches/lan/cisco_ie3000/software/release/12-2_50_se/configuration/guide/ie3000scg/swstpopt.html#wp1031116
                                               Leave it blank , which defaults to 'edge' (too)

  M.

[Giuseppe Larosa · Accepted solution]

Hello @MartinNantus11364 ,

use

spanning-tree portfast

with no other parameter

Hope to help

Giuseppe

[MartinNantus11364]

Thank you both gentlemen!  I'll go with the "default" in hopes of confusing my boss. (^_^)