Hi,
On this model, if you use both method:
- Port based configuration using the mls qos interface based commands OR
- MQC based configuration using class-map and policy-map
Which of these is applied to the interface? I know from other catalyst switches when you configure the port with the service-policy input <policy-map-name> command, it removes the mls qos trust cos command automatically but not on this model.
Config details below:
GigabitEthernet1/0/6
Attached policy-map for Ingress: POL-MAP
trust state: trust cos
trust mode: trust cos
trust enabled flag: ena
COS override: dis
default COS: 0
DSCP Mutation Map: Default DSCP Mutation Map
Trust device: cisco-phone
qos mode: port-based
interface GigabitEthernet1/0/6
switchport access vlan 107
switchport mode access
switchport nonegotiate
switchport voice vlan 207
no logging event link-status
no logging event power-inline-status
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust device cisco-phone
mls qos trust cos
dot1x pae authenticator
spanning-tree portfast
spanning-tree bpduguard enable
service-policy input POL-MAP
Thank you in advance.
