I came across an interesting issue and thought I would see if anyone else has encountered it before contacting TAC...
I have two Cisco Catalyst WS-4510R-E switches with a single Supervisor V module in each chassis. Both Sup cards are now running 12.2(54) SG1; ipbasek9 firmware; yes, I plan to move both switches to 15 code but that's another story. Anyways, prior to the upgrade the one switch was running 12.2 (33) code; I suspect the code was never upgraded; running ipbase non - K9 code. The other switch was running 12.2(44) with K9 prior to upgrade to 12.2(54). With the background set, one switch reports the following:
SwitchA (config)#r?
radius-server redundancy regexp rep
resource rmon route-map router
Here is the output from Switch B.
SwitchB (config)#r?
redundancy regexp rep resource
rmon route-map router
That's right, Switch B doesn't list "radius-server" in the global configuration. It will list the following
(config)#ip radius ?
source-interface
I initially thought it was a software issue with 12.2 (44) but it appears the missing "radius-server" problem followed upgrading to 12.2(54)SG1. I even tried entering the command thinking it may still support radius-server but get the following response.
SwitchB(config)#$radius-server host 10.0.0.1 key gotokey
radius-server host 10.0.0.1 key gotokey
^
% Invalid input detected at '^' marker.
Any ideas other than contact TAC?
Thanks in advance.
