Redundancy mode sso

[vrtyler70]

I have a new Model: WS-C3850-48P, SW Version: 03.07.00E, SW Image: cat3k_caa-universalk9. It is setup in the below settings but I am not running a pair of these switches. Are these switches setup in this manner by default? Can the redundancy be disabled if I am not going to use redundancy? What are the commands to disable redundancy?

switch 1 provision ws-c3850-48p

hw-switch switch 1 logging onboard message level 3

redundancy
 mode sso

Thanks in advance,

Vtyler

[Reza Sharifi · Accepted solution]

Hi,

No need to worry about that command since you only have one switch.  This command is enabled in all newer Cisco switch models.

HTH

[vrtyler70]

Thank you for your help and quick response!