I reset one of our switches so I could changes the IP address and configure for a different location.
To reset the switch:
•Press and hold the Mode button. The switch LEDs begin blinking after about 2 seconds. Continue holding down the Mode button. The LEDs stop blinking after 8 more seconds, and then the switch reboots.
Wait for the switch to complete POST.
Verify that POST has completed by confirming that the SYST and STAT LEDs are green.
Press and hold the Mode button for 3 seconds. When all of the LEDs above the Mode button turn green, release the Mode button.
Verify that the switch is in Express Setup mode by confirming that all LEDs above the Mode button are green. (The RPS LED remains off on this switch.)
Everything works fine until this point. I connect a straight-through Category 5 Ethernet cable to one of the Ethernet port on the switch front panel and to the Ethernet port on the PC.
The LED's on both bink on the switch it's green and on the pc yellow. And I can't get to the express setup page.
The switch home page loads. But if I click on the Web Console link, I get page not found.
I tryed it with different pc's and still the same. What am I over looking?
Thanks,
DJ
