Router 1841 new user

[Edi.Brata]

Hello anyone,

I'm trying to add a new admin user on router 1841.

I usually use SDM to access router but I didn't find any command line there.

I've tried through terminal, but it tells me:

router#username ***** privilege 15 secret 0 *******

            ^

% Invalid input detected at '^' marker.

What to do?

thanks in advance!

[chandra_rc16]

Hi Edi,

You can't configure that in Privilege-exec mode. You need to enter into global configuration prompt and then use the below command. Here i'm configuring racha as a user with privilege level 15.

Don't forget to rate the helpful posts.

Regards,
Chandu

[Edi.Brata]

Please Chandu

again some help

how to enter to global configuration prompt?

        Should I write all the command you show above?

[acampbell]

Hi Edi,

from the router prompt

config term ( you again abrieviate)

router#config t

router(config)#

Now you can add your config lines

Regards,
Alex.
Please rate useful posts.

[Edi.Brata]

thanks guys

what about changing the Internet IP

let's say from 95.107.1.1 to 95.161.1.1 (just for exmple)

what command to use?

[cadet alain]

Hi,

You would first have to ask the ISP to get a new IP if it was a static one.

Regards

Alain

Don't forget to rate helpful posts.

[Edi.Brata]

yes sure, I'll have the static IP soon

but what's the command to configure it?

thanks!

[Richard Burts]

The commands would be like this

config t

interface fastethernet0/0

ip address 95.161.1.1 255.255.255.240

HTH

Rick