Router IOS

mahesh-gohil · ‎01-24-2007

Dear all,

We are using cisco 3632 DCN for out transmisssion equipment network.

Now after IOS upgradation We found output of show ver as follows

#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C3631 Software (C3631-TELCO-M), Version 12.2(11)T10, RELEASE SOFTWARE (fc3)

Compiled Sat 25-Oct-03 10:45 by eaarmas

Image text-base: 0x60008940, data-base: 0x60FFA000

ROM: System Bootstrap, Version 12.2(8r)T2, RELEASE SOFTWARE (fc1)

# uptime is 3 days, 7 hours, 55 minutes

System returned to ROM by bus error at PC 0x0, address 0x0

System restarted at 01:52:24 IST Sun Jan 21 2007

System image file is "flash:c3631-telco-mz.123-14.T7.bin"

as u can see it show IOS as 12.2(11)T10 and system image file is flash:c3631-telco-mz.123-14.T7.bin

what does it mean

Regards

mohammedmahmoud · ‎01-24-2007

Hi there,

Most probably, the 12.3 image has a problem, which caused the router to reboot and use another image from the flash, which was indicated by:

"System returned to ROM by bus error at PC 0x0, address 0x0"

Troubleshooting Bus Error Crashes

Cisco IOS Software Loaded Does Not Support Installed Hardware

Best regards,HTH,

Mohammed Mahmoud.

mahesh-gohil · ‎01-25-2007

Thanks mohammed,

But tell me the solution of this problem

how can i ignore problem on next reload

B'se last time when I have reloaded it has gone in boot loop. and I have to insert IOS via Xmodem

Regards

Mahesh