setting up NAT and possibly PAT on CIsco 800 series router

[tekky1988]

Hi There,

I have a Cisco 800 series router that I need to set NAT up on. There will be four computers connecting to the internet through it. I already have the IP address coming from my cable modem I just do not know the command to get it to translate to my internal dhcp pool I have setup. I have also been doing some research, seeing as I only have one public IP address coming from my ISP will I have to use PAT as well?

any help you can give would be appreciated.

Thanks

tekky1988

[johnlloyd_13]

hi david,

please see useful link in setting up your NAT:

http://www.cisco.com/en/US/technologies/tk648/tk361/tk438/technologies_white_paper09186a0080091cb9.html