12-02-2013 02:35 AM - edited 03-07-2019 04:52 PM
After configuring SPAN on 2960, IDS can't connect to anything, IDS & PC client same switch on 2960
Please correct the below configuration.
interface GigabitEthernet0/1
description " To L3 3750"
switchport mode trunk
!
interface GigabitEthernet0/11
description "PC client"
switchport access vlan 8
!
interface GigabitEthernet0/11
description " To IDS"
switchport access vlan 8
monitor session 1 source interface Gi0/2
monitor session 1 destination interface Gi0/3
Switch#sh monitor
Session 1
---------
Type : Local Session
Source Ports :
Both : Gi0/2
Destination Ports : Gi0/3
Encapsulation : Native
Ingress : Disabled
12-02-2013 02:41 AM
check the output rate on the destination interface. 2960 uses shared buffer. Make sure the span is not overwhelming the buffer available.
Thanks & Regards,
Karthick Murugan
CCIE#39285
11-13-2014 12:37 AM
Hi All,
Is there supported document that said about buffer/cpu consumption at Cat-2960 during running SPAN monitor ?
Thanks,
Rakhmad
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide