cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
452
Views
0
Helpful
1
Replies

spanning tree blocks both uplinks to 9300 distribution switches

Hi,

 

We have recently replaced a pair of legacy distribution switches (WS-C3750X-12S-E) with a pair of 9300's (C9300-24S-A). The config is identical, and so are the SFP's (and are compatible with this unit). The access switch downstream (WS-C3560X-48) has two up links - one for each distribution - and was working fine with the old switches. when we replaced the distribution with the 9300's - we saw loop back errors on the access switch and some inconsistent vlans, this forced both uplinks into error disabled state. after doing a shut and no shut on both interfaces - everything worked perfectly fine. we believe that this may have occurred because of spanning-tree incompatibilities between the 9300's and the access switch. can anybody confirm if this is possible, or what could have caused this issue ?

 

a diagram of the set-up has been drawn bellow:

 

 

                     --------[9300-dist01] 
[3560x]----[
                     --------[9300-dist02]

 

 

Best Regards,

 

Sabeel

1 Reply 1

marce1000
VIP
VIP

 

 - Check current software version on the 9300 , -> use latest advisory release , check if that can help. If problems persist afterwards, post log entries here related to the problems you are observing.

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco