SRW224G4P Boot Image

[fredyip123]

I have a SRW224G4P and when I boot up it has the following error:

Image Loader 1.0.1

<ERR> Diagnostic Loading Fail - Try Runtime

Loading Runtime Image File : SRW224G4P_SRW248G4P_image.bix

And it then tries to boot from Runtime file and it seems to boot up and I get the Menu.

However, I think I'm having problem getting the switch to talk via TCP, and webview. So I'm trying to fix a problem at a time.

When I do a Ctrl+U to interrupt the boot process:

it seems like I do not see a boot image bix file, which in another discussion thread seems like that I'm suppose to have the following file?

SRW224G4P_SRW248G4P_boot.bix        1    1    1377600  00:01:03

I only have the SRW224G4P_SRW248G4P_image.bix and not the *boot.bix.  

Is it the problem causing my boot error? If so, where can I get a copy of this file and instructions to fix this?

Regards,

Fred

[piotrkuchciak]

I have the same problem.

I deleted a file by mistake SRW224G4P_SRW248G4P_boot.bix

I have uploaded the file SRW224G4P_SRW248G4P_image.bix by HyperTermina to XMODEM and it is ok but runs Switch LED power light flashes orange. Blinking rapidly ...

Image Loader 1.0.1
Diagnostic Loading Fail - Try Runtime
Loading Runtime Image File : SRW224G4P_SRW248G4P_image.bix
Runtime 1.0.2

Pass
root init done

Set Transition mode ...
[get stackingMac done ret_val] = 1
Assigned Unit ID:[1]
stacking DB: unit = 0, module type = 0

Finish Set Transition mode ...
Enter Transition mode ...

The console HyperTermina startup but I have a message switch starts up and asks:

................................................................................
..........................................................
Notify provision complete

CLI provision has been completed

Provision Complete ...
Finish Provision Complete ...
[get stackingMac done ret_val] = 1
XFER: End of config sync.

Please press to start Menu session!

Yes works ok but do not have access to the WebGUI and the MAC address is all zeros and boot version is empty

System Description: 24 10/100 ports and 4 gigabit ports with PoE switch

Systme Up Time:     0, 0:6:34 

System Mac Address: 00-00-00-00-00-00

System Contact:

System Name:

System Location:

                          Boot Version:

                        Software Version:     1.0.2

                        Loader Version:       1.0.1

                        Hardware Version:

Where i can download file boot and how i can upload it on switch.