02-12-2013 06:49 AM - edited 03-07-2019 11:40 AM
Good afternoon all,
I have two 6509s both with single FWSMs running in transparent mode with bridged Inside and Outside VLANs.
I have my Core A set to STP priority of 8192 and Core B set to 16,384 to make Core A the root for all VLANs.
Problem I have is when I look at spanning-tree on Core A for Inside VLAN 324 it states to get to the Root go via PO100 (Cost of 9) and that the Root also has a Priority of 8192, but as the designated Root has a lower MAC address it's pointing to the etherchannel. PO100 is L2 Etherchannel between the Cores.
Moving accross PO100 to Core B and running the show spanning-tree command I can see that to get to the Root Bridge I need to go via PO272. PO272 is the internal Etherchannel to get to the FWSM on the Core B Switch. This shows a cost of 6 to get to the Root and a mac address of the Root Bridge which resides on Core A (Outside VLAN 124)
To give some perspectibe,theoutside VLAN of the pair has it's STP ROOT on the Core A switch as intended
Any help would be much appreciated
David
02-12-2013 12:00 PM
Hello David,
Can you try specifying the stp root via the primary/secondary commands - spanning-tree vlan xxx root primary/secondary. instead of specifying the priority value, this will decrease its own priority value if another switch challange's for stp root with it present priority vlaue.
Also you could apply spanning-tree rootguardto protect your root switch designated ports becoming root ports towards a new stp root switch
To influence a directly connected downstream switch from the root to elect its stp root port use - spanning-tree vlan x port-priority x ( highest value less preferred)
To influence a local switch towards the root to elect its stp root port use - spanning-tree vlan x cost y ( highest value less preferred)
Welcome any other CSCr's to jump in here and correct me if i am wrong?
res
Paul
Please don't forget to rate this post if it has been helpful.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide