Has anyone had any success setting up inter-VLAN routing with the SG200-50P 50-Port Gigabit PoE Smart Switch? I recently started working at a new company that is using these (I wouldn't have picked them). However, I cannot figure out for anything how to get a ROAS to work right. Have spent 2 whole days working on this. I have the VLANs set up. Inside of VLAN 2, for an example, I can ping the gateway and I can ping the gateway of VLAN 3. I cant ping other devices in VLAN 2 or VLAN 3. I'm sure it has something to do with all of the VLAN interface settings. I could do this no problem in CLI, but cant get the GUI to work.
I am attaching screenshots of the VLAN configs on the switch.
I do not have personal experience with the SG200 switches and would be glad if anyone who does have experience would share that with us. I took a look at the product data sheet and at the administrative guide and it looks like these are layer 2 switches and do not have the capacity to perform inter vlan routing.
Right. They cannot perform Inter-VLAN routing. I have a Cisco 1921 Router with 4 sub interfaces doing the actual routing. Will replace the 1921 with a Layer 3 Switch once this proof of concept is complete, but will be keeping the SG200s as the Layer 2 devices.
Sorry. Cisco kicked me out. Just got back in.
NO I do not have VLANs set up on the router. when I tried to set up VLANs it gave an overlap error with the sub interfaces. So I assumed this model didn't support that.
I have subinterfaces of the port. Here is their config.
encapsulation dot1Q 2
ip address 192.168.60.254 255.255.255.0
encapsulation dot1Q 3
ip address 192.168.70.254 255.255.255.0
Attached is the config to the uplink port